TRENDnet TEW-820AP - Connect Wireless Devices to Your Access Point

TRENDnet User’s Guide
TEW-820AP
Selecting WPA Enterprise:
The following section outlines options when selecting WPA (EAP or RADIUS). This
security type is also known as EAP (Extensible Authentication Protocol) or Remote
Authentication Dial-In User Service or RADIUS.
Note: This security type requires an external RADIUS server, Pre-Shared Key only requires
you to create a passphrase.
• Security Mode: Select WPA-Enterprise
• WPA Mode: Select WPA2 Only, WPA Only or Auto (WPA or WPA2). It is
recommended to select WPA2 Only, but if you are not certain you can select Auto.
• Cipher Type: Select AES when using WPA2 only, TKIP when using WPA Only. You
can select TKIP and AES when using Auto (WPA or WPA2)
• RADIUS Server IP Address: Enter the IP address of the RADIUS server. (e.g.
192.168.10.250)
• RADIUS Port: Enter the port your RADIUS server is configured to use for RADIUS
authentication.
Note: It is recommended to use port 1812 which is typical default RADIUS port.
• RADIUS server Shared Secret: Enter the shared secret used to authorize your
access point with your RADIUS server.
Connect wireless devices to your access point
A variety of wireless network devices can connect to your wireless network such as:
Gaming Consoles
• Internet enabled TVs
• Network media players
• Smart Phones
• Wireless Laptop computers
• Wireless IP cameras
Each device may have its own software utility for searching and connecting to available
wireless networks, therefore, you must refer to the User’s Manual/Guide of your
wireless client device to determine how to search and connect to this access point’s
wireless network.
See the “Appendix
” on page 44 for general information on connecting to a wireless
network.
© Copyright 2014 TRENDnet. All Rights Reserved.
13