© Copyright 2015 TRENDnet. All Rights Reserved.
USB 3.0/2.0 Share Ports
Plug in a USB 3.0 flash or storage drive into the SuperSpeed USB 3.0 or the USB 2.0 share
port
Guest Network
Create an isolated network for guest internet access only
Parental Controls
Control access to specific websites
One Touch Connection
Securely connect to the router at the touch of the Wi-Fi Protected Setup (WPS) button
Targeted Beamforming
Increased real-time performance by directing stronger wireless signals to your specific
location
1 GHz Processor
Extreme performance 1 GHz dual core processor optimizes networking throughput
VPN Support
Secure remote access to the router with OpenVPN support
*Maximum wireless signal rates are referenced from IEEE 802.11 theoretical
specifications. Actual data throughput and cover-age will vary depending on
interference, network traffic, building materials and other conditions. For maximum
performance of up to 1.3 Gbps use with a 1.3 Gbps 802.11ac wireless adapter. 802.11n
2.4 GHz TurboQAM speeds requires clients with TurboQAM support.
Product Hardware Features
Rear View
Connect USB storage devices to share over the
network via FTP or Windows® SMB/CIFS, Samba.
Connect USB storage devices to share over the
network via FTP or Windows® SMB/CIFS, Samba.
WPS Button (Wi-Fi
Protected Setup)
Push and hold this button for 3 seconds to activate
WPS. The Power LED will blink when WPS is activated.
Connect Ethernet cables (also called network cables)
from your router LAN ports to your wired network
devices.
Connect an Ethernet cable from your router Internet
port to your modem.
Push the router On/Off power switch to turn your
router “On” ( - ) or “Off” (O).
Connect the included power adapter from your router
power port and to an available power outlet.
Press and hold this button for 10 seconds to reset the
router.
6 External High Gain
Antennas