Section 7
Operation
Warning : Dryspell Plus dryers are designed and manufactured for drying compressed air. Under no circumstances
should they be used to dry any other gases.
Warning : The adsorbents used in the dryer are non-toxic. However, they may cause respiratory problems if they are
inhaled as dust. The use of dust masks is sufficient to protect personnel.
Warning: This dryer should be used for drying only filtered compressed air. Ensure that the air supplied to the inlet
of this air dryer is filtered. Failure to follow this instruction can lead to serious injury or death.
7.1 Do's and don'ts
l Do not turn on or operate the dryer if there is a leak.
l Make sure that the dryer's protection rating matches the conditions at your installation
l Verify that the voltage of the power supply matches the voltage marked on the data label
l Do not operate the dryer at pressures above the maximum allowable limits marked on the data label. This label is found
on the leg of the dryer
Figure 7. Name plate of Dryspell Plus dryer
7.2 Turning the dryer on
Always pressurise the dryer before powering it up:
l Make sure that the power supply to the dryer is turned off
l Open the bypass valve and close the outlet valve
l Open the inlet valve and pressurise the dryer
l Open the outlet and close the bypass valve
l Turn on the power to the dryer
INSTRUCTION MANUAL - Dryspell Plus
Reference : Manual Version
14
To Next Page
Loading...
