Trident DRYSPELL PLUS 10 - Changing the Inlet Tube

8.5.2.5 Changing the inlet tube
Figure 18. Exploded view of Dryspell Plus models 20 and 30
l Unfasten the dome nuts, and remove the washers
l Remove the top block with the filter and controller
l Discard the inlet air transfer tube
l Discard the O-rings (10.6 * 1.83)
l Fix a new inlet air transfer tube on the bottom block with new O-rings
l Fix the top block
l Fasten the dome nuts with the washers
29