T100e thermostatic care & care plus
17
the temperature stop can be adjusted by the
installer to lock at a selected temperature setting,
according to individual needs.
Procedure
With the cover in place, start the shower as
normal. Set the temperature control to the
maximum required temperature. This can
be with the pointer positioned at any point
between 1 and 10 on the front cover markings.
Make a note of your chosen maximum position.
Turn off the shower and isolate the electricity
supply at the mains.
With a suitable screwdriver, unscrew the three
cover retaining screws and lift the cover from the
backplate.
Inside the cover is the temperature control
(fig.24). With a suitable screwdriver, remove
the centre screw from the adjustable stop.
IMPORTANT: Take care not to disturb the
temperature lever on the front cover from the
position selected.
Lift out the adjustable stop and reposition it at
position ‘A’ (fig.25). Screw the stop back into
position.
IMPORTANT: DO NOT rotate the valve
spindle when the cover is removed as this will
alter your selected temperature.
Offer the cover to the unit and carefully locate
the cover tags into the guide pockets, and the
control spindle into the cover correctly. While
applying slight pressure to the cover, secure in
place with the three retaining screws.
Switch on the electricity supply and start the
shower.
Check that the temperature control lever locks
at a position which provides a satisfactory
showering temperature for all users.
Note: It is advisable to be certain that the
showering temperature is satisfactory by testing
with your hand before stepping under the
showerhead.
There will always be a time delay of a few
seconds between selecting a temperature
and the water reaching the stable selected
temperature.
Adjustable
stop
Centre
screw
Fig.24
Fig.25
CAUTION!
It is recommended that persons who
may have difficulty understanding or
operating the shower controls should
not be left unattended while using
the shower. Special consideration
should be given to young children and
the less able bodied.
W-020-A
WARNING!
This appliance is not intended for use
by young children or infirm persons
unless they have been adequately
supervised by a responsible person to
ensure that they can use the appliance
safely.
Young children should be supervised to
ensure that they do not play with the
appliance.
To Next Page
Loading...
