T100e thermostatic care & care plus
22
1 Shower inoperable.
2 Water flows when
isolating switch is
switched on.
3 Water too hot.
4 Unstable shower
temperature or flow.
5 Water too cool or
cold.
6 Low pressure
indicator flashing.
1.1 Interrupted power
supply.
1.2 Unit malfunction.
2.1 Ribbon cable is
not connected.
2.2 Unit malfunction.
3.1 Temperature
control incorrect
setting.
3.2 Unit malfunction.
4.1 Blockages.
4.2 Loose ribbon cable
connection.
4.3 Unit malfunction.
5.1 Temperature
control incorrect
setting.
5.2 Unit malfunction.
5.3 Safety cut-out
operated.
6.1 Water pressure
has dropped below
minimum required.
6.2 Blockage in outlet.
6.3 Loose connection
on PCB.
1.1.1 Blown fuse or circuit breaker. Check
supply. Renew or reset fuse or circuit breaker. If it
fails again, consult a qualified electrician.
1.1.2 Power cut? Check other appliances and if
necessary, contact local Electric Supply Co.
1.2.1 Have unit checked by suitably qualified
electrician or contact Customer Service.
2.1.1 Switch off the electric supply, remove the
shower cover and plug in ribbon cable.
2.2.1 Contact Customer Service.
3.1.1 Turn anti-clockwise.
3.2.1 Contact Customer Service.
4.1.1 Clean showerhead. Check inlet filter.
4.2.1 Check connections on PCB.
4.3.1 Contact Customer Service.
5.1.1 Turn clockwise.
5.2.1 Contact Customer Service.
5.3.1 The thermal safety cut-out device has
operated. Have unit checked by suitably qualified
electrician or contact Customer Service.
6.1.1 Wait until water pressure has returned to
normal.
6.2.1 Check and clean outlet and/or
showerhead.
6.3.1 Check connection on PCB from pressure
switch.
Fault finding
FAULT FINDING
IMPORTANT: Switch off the electricity at the mains supply and remove the circuit fuse before
attempting any fault finding inside the unit.
Problem/Symptom Cause Action/Cure
To Next Page
Loading...
