GENERAL INFORMATION
47
If the DRL switch is in the daytime
running lights position, push the high
beam switch forward to turn the high
beam on. When the high beam switch is
returned to the central position the DRL
will be activated again.
A lighting on/off switch is not installed
on this model. The position light, tail
light and license plate light all function
automatically when the ignition is on.
The headlight and DRL will function
when the engine is on.
Heated Grips Button (if equipped)
The heated grips will only heat when
the engine is running.
When the heated grips are turned on,
the heated grips symbol will appear and
the selected heat level will be shown in
the display. When the heated grips are
turned off, the heated grips symbol is
no longer shown, see page 34.
1
1. Heated grips symbol
For maximum benefit in cold conditions,
from the OFF position and after a
push to show the current heated grips
status, push the switch twice for the
high heat setting initially and then
reduce the heat level by pushing the
switch twice again for a low heat setting
when the grips have warmed up.
Low Power Voltage Cut Off
If a low voltage is detected, the heated
grips will power off. The heated grips
will not function again until the voltage
rises to a safe level.
The heated grips will not power back on
automatically even if the voltage rises to
the safe level. The user must manually
push the button again to activate the
heated grips.
To Next Page
Loading...
