Triumph Speed 400 - Left Handlebar Switches

GENERAL INFORMATION
46
Left Handlebar Switches
cldn
1
2
3
6
5
4
5
1. Dipped beam/Daytime Running Lights
(DRL) switch (if equipped)
2. Turn signal switch
3. Horn button
4. Heated grips button (if equipped)
5. High beam switch
6. SCROLL/SELECT button
SCROLL/SELECT Button
The SCROLL/SELECT button is used to
operate the following functions of the
instruments:
▼ Odometer (see page 32)
▼ Trip meters and reset (see page 35)
▼ Average fuel consumption and reset
(see page 36)
▼ Traction control (see page 37)
▼ Off-road mode (see page 37)
▼ Clock (see page 37)
▼ Units (see page 37).
Dipped Beam/Daytime Running Lights
(DRL) Switch (if equipped)
NOTICE
Daytime running lights are manually
operated. They are not automatic.
The daytime running lights or dipped
beam can be selected with the Daytime
Running Lights (DRL) switch.
To select daytime running lights,
push the dipped beam/DRL switch
downwards.
To select dipped beam, push the dipped
beam/DRL switch upwards.
When the daytime running lights are
turned on, the daytime running lights
indicator light will illuminate in the
instrument panel.
Turn Signal Switch
When the turn signal switch is pushed
to the left or right, the corresponding
turn signals will flash on and off.
The turn signals can be canceled
manually. To manually turn off the turn
signals, push and release the turn signal
switch in the central position.
Horn Button
When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.
High Beam Switch
This is a three position switch.
When the high beam switch is pushed
forward the high beam will be switched
on. Push the switch back to the central
position to turn the high beam off. The
high beam will only come on when the
engine is running or the motorcycle is
moving at greater than 3 mph (5 km/h).
Push and release the switch rearwards
to engage a flash function. Releasing
will return the switch to the central
position and turn the high beam off.
If daytime running lights are installed on
the motorcycle, the high beam switch
has additional functionality.