MAINTENANCE AND ADJUSTMENT
94
NOTICE
If the engine oil pressure is too low,
the low oil pressure warning light will
illuminate.
If the low oil pressure indicator
remains on, stop the engine
immediately and investigate the
situation.
Running the engine with low oil
pressure will cause severe engine
damage.
▼ Stop the engine, then wait for at
least five minutes to allow the
engine oil to settle.
▼ Recheck the engine oil level. Adjust
if necessary, see page 89.
▼ Position the front left engine cover
and install the fasteners. Tighten to
8 lbf ft (11 Nm).
1
2
2
2
1. Front left engine cover
2. Fasteners
▼ Position the front left cover finisher
and install the two fasteners.
Tighten to 62 lbf in (7 Nm).
Engine Oil Specification and Grade
(10W/50)
Triumph's high performance fuel
injected engines are designed to use
fully synthetic 10W/50 motorcycle
engine oil which meets specification
API SN (or higher) and JASO MA2. Semi
synthetic engine oil must not be used.
Triumph Performance fully synthetic
engine oil is recommended.
NOTICE
The engine oil grade specified must be
used.
Using the incorrect engine oil grade
may result in engine damage.
Do not add any chemical additives
to the engine oil. The engine oil also
lubricates the clutch and any additives
could cause the clutch to slip.
Do not use mineral, vegetable, non-
detergent oil, castor based oils or any
oil not conforming to the required
specification. The use of these oils may
cause instant, severe engine damage.
Make sure that no foreign matter enters
the crankcase during an engine oil
change or top off.
To Next Page
Loading...
