tronical Tune - Getting Started: Tuning Procedures; Re-Tuning Process; Changing Tuning Modes (Single;Multi-String)

WWW.TRONICAL-COMPONENTS.COM
14
STRUM BY THUMB, CLOSE TO THE NECK JOINT SOUND HOLE, 1 STRUM = ALL STRINGS WITHIN 1 SEC.
WAIT 35 SECONDS BETWEEN TWO STRUMS
AFTER STRUMMING, MUTE STRINGS THAT ARE ALREADY IN TUNE GREEN LED ON TUNE CONTROLLER AND
STRUM THE OUTOFTUNE STRINGS ONLY.
To change the actual tuning (e.g. from Standard to DADGAD) you can select the “SINGLESTRING MODE” or the “MULTISTRING MODE” .
SINGLE STRING MODE is activated with a PRESS AND HOLD “ENTER“
MULTI STRING MODE is activated with a PUSH, “ON“ button (for details please refer to “Tune Mode page 15 and following”).
SINGLE STRING MODE is recommended to get familiar with the system and when you use the system in a loud environment with ambient noise
(especially with acoustic guitars).
MULTISTRING MODE is recommended as the default mode as soon you are used to the system.
HOW TO TUNE / ADDITIONAL INFORMATION
RETUNING
CHANGE TUNING
GETTING STARTED
1
1
2
3
!
PLEASE NOTE THE BASS SIDE ROBOHEADS TURN IN THE OPPOSITE DIRECTION FROM USUAL.
THEY NOW TURN CLOCKWISE TO SHARPEN AND COUNTERCLOCKWISE TO FLATTEN.