tronical Tune - Configuration Menu: Interference Level; Adjusting Interference Level; Preventing Harmonic Interference

WWW.TRONICAL-COMPONENTS.COM
32
BAT
e B G D A E
MENU
BAT
e B G
MENU
BAT
MENU
SETS THE GLOBAL INTERFERENCE LEVEL FOR ALL TUNING MODES.
DEFAULT IS 3LEDS
PUSH “LEFT/RIGHT“ to select between a high and low interference level to
prevent that the harmonic of a low string is recognized as a harmonic of a high
string.
E
E
A
A
D
DGBe
e
LEFT / RIGHT
ENTER
INTERFERENCE LEVEL
BACK
HIGH
LOW
EXAMPLE: HIGHEST INTERFERENCE LEVEL.
INTERFERENCE LEVEL
e
CONFIGURATION MENU
PUSH “ON“ button. The system comes up with the last completed
tuning in MULTISTRING MODE.
PUSH “BACK“ button to enter TUNING SELECTION MODE. MENU LED IS OFF.
To enter CONFIGURATION MENU
PRESS AND HOLD “DOWN“ BUTTON until MENU and “E“ LED TURNS LIGHT
BLUE.
TO ACCESS INTERFERENCE LEVEL SELECT “e“LED and PRESS ”ENTER”.
ENTER
DOWN
LEFT / RIGHT
ON/BACK
i
i
A GUITAR STRING IS PRODUCING NOT ONLY THE FUNDAMENTAL
FREQUENCY BUT ALSO SEVERAL OVERTONES E.G. THE E STRING IS
PRODUCING 82.41 HERTZ AS FUNDAMENTAL AND OVERTONES AT
164.82, 247.23 AND SO FORTH.
THAT MEANS THAT THE ESTRING IS INTERFERING WITH THE BSTRING
BECAUSE THE SECOND OVERTONE OF THE ESTRING AND THE FUNDA
MENTAL OF THE BSTRING INTERFERE AROUND 247 HERTZ.
WHEN YOU RECOGNIZE THAT THE ROBOHEAD OF THE B STRING IS
TURNING WITHOUT PLUCKING THE BSTRING REDUCE THE INTERFE
RENCE LEVEL. IF YOUR GUITAR IS NOT PRODUCING PRONOUNCED
OVERTONES YOU CAN INCREASE THE INTERFERENCE LEVEL TO
IMPROVE PERFORMANCE.