Technical Data
3.2 Electrical requirements of the machine
Laser power 35–50 W (CO
2
)
10-50 W (fiber)
AC
55–80 W (CO
2
)
10-50 W (fiber)
AC
85–100 W
(CO
2
)
10-50 W
(fiber)
AC
105–120 W
(CO
2
)
10-50 W
(fiber)
AC
Voltage 230VAC 115VAC 230VAC 115VAC 230VAC 230VAC
Fuse 8AT 16AT 10AT 16AT 12AT 12AT
Power consumption 1200 W 1200 W 1400 W 1400 W 1900 W 1900 W
AC = air condition
Caution
Inadequate or inappropriate power sources can lead to machine damage and are not covered
by any liability.
Verify that the electrical outlet is capable of providing the proper voltage, frequency and
amperage required by the laser machine described in this manual.
Caution
Electrical noise, unstable power supply as well as voltage spikes in power supply can cause
interference and possible damage to the electronics of the laser machine.
Notice
Use an individual circuit for the laser machine and the PC and an individual circuit for the
exhaust system. Install your computer to the same circuit as the laser machine to prevent
electromagnetic interactions.
Furthermore it is highly recommended that you use a overvoltage protection switch to protect
your computer equipment.
If electrical power fluctuations, brownouts or power outages are a problem in your area, an
electrical line stabilizer, UPS (Uninterruptible Power Supply) or backup generator are required.
When installing any of these devices, ensure that they meet the electrical requirements of the
laser machine.
32
To Next Page
Loading...
Need help?
General
