Trotec Speedy 360 flexx - Switch Laser Source Manually

Operation
7.6 Switch laser source manually
Notice
Only possible for flexx laser systems.
Switching between CO
2
laser source and fiber laser source is done either manually by pressing a shortcut on
the control panel, or by making settings in JobControl®.
Procedure for manual switching between CO
2
laser source and fiber laser source:
1) After referencing the machine,
press "standby".
2a) Selection: CO
2
laser source
Press the marked shortcut
simultaneously to switch to the
CO
2
laser source.
2b) Selection: fiber laser source
Press the marked shortcut
simultaneously to switch to the
fiber laser source.
68