Setup and installation
6.5.1 Mains connection
•
Connect the end of the mains connection cable to the main connection socket.
Warning Current
Wrong voltage can cause damage to the machine.
Do not operate the machine, if the mains voltage does not match the voltage required by the
exhaust system, as this may cause damage to the machine.
Make sure that the mains voltage matches the voltage required by the exhaust system.
Notice
Depending on the laser type and region, the main fuses (6) are either covered or open next to
the connector.
6.5.2 Connection the PC
1. Connect the laser to a free interface or USB port on your computer.
2. Connect the computer to the mains.
3. Switch on the computer.
56
To Next Page
Loading...
