What to do if Trotec Speedy 360 flexx Printer is not engraving deeply enough?
If your Trotec Printer is not engraving deeply enough, it might be due to imprecise focusing. In this case, you should check the focus. Also, dirty optics can cause this issue, so ensure you clean the optics.
Why is my Trotec Speedy 360 flexx Printer not cutting lines?
If your Trotec Printer is missing cut lines, it could be due to a few reasons. The material database might have zero passes, so increase the amount of passes in the JobControl® material database. If the line thickness in Corel Draw is too big, reduce it to the smallest possible value. Also, the color might have been skipped in JobControl®; if so, set the color to cutting in the JobControl® database.
To Next Page
General
