WARNING
Improper assembly or setup can cause serious injury or damage. For this reason, this
work may be carried out only by authorized, trained personnel who are familiar with how
to operate the machine and in strict observance of all safety instructions.
An incomplete, faulty or damaged machine can lead to serious physical injury or property
damage. Assemble and install the machine only if the machine and its parts are complete
and intact.
Operate the machine only in ambient temperatures from +15 °C to +25 °C (+59 °F to
+77 °F). Relative humidity must not exceed 40% – 70% (non-condensing). If the
instructions are not followed, damage may occur during operation.
If the system has been subject to significant temperature fluctuations, it must be brought
back to room temperature before being commissioned.
A laser system consists of high-quality electrical and optical components. Mechanical
stresses, vibrations and impacts must always be avoided.
WARNING
Work on electrical fittings may be carried out only by qualified personnel and in strict
observance of the safety notes.
Note the following:
Ensure that there is sufficient distance to neighboring machines, walls or other fixed equipment.
Keep the work area orderly and clean.
Before assembling and installing the machine, check it to make sure it is complete and in good
condition.
To Next Page
Loading...
Need help?
General
