2 Safety
At the time of the development and production of the machine, it was built in accordance with
recognized technological regulations and is therefore considered operationally safe.
However, hazards may arise if the machine is used improperly, operated by untrained personnel or
employed for purposes other than those it was designed for.
The present chapter provides an overview of all important safety considerations necessary to ensure
safe and trouble-free operation of the machine.
Other chapters of this manual contain specific safety instructions which are marked with symbols in
order to avert dangers.
2.1 Safety principles
2.1.1 Intended use
The machine described in this manual is intended exclusively for laser marking using the
supplied marking software.
For material details see chapter “Materials” or contact your local Trotec salesperson or Trotec
technical support.
The system must be operated, maintained and repaired only by trained personnel familiar with the
designated field of use and the dangers of the machine!
Operate the machine only in technically flawless condition and when it fully complies with the EC
Machinery Directive.
The intended use of this machine also includes that all personnel involved in installation, set-up,
operation maintenance and repair of the machine must have read and understood the Operation
Manual and in particular the “Safety” section, and comply with the instructions.
2.1.2 Improper use
Use of the machine for any purposes other than those intended or described in the present manual is
regarded as improper and therefore prohibited.
Trotec will not accept any liability for damage caused by improper use. The risks in case of improper
use are exclusively borne by the user.
Non-observance of the operation, maintenance and service instructions described within this manual
absolves Trotec from any liability in case of a defect.
To Next Page
Loading...
Need help?
General
