Setup and installation
6.6 Connection of additional components
6.6.1 Connecting an exhaust system from Trotec
Warning Current
Wrong voltage can cause damage to the machine.
Do not operate the machine, if the mains voltage does not match the voltage required by the
exhaust system, as this may cause damage to the machine.
Make sure that the mains voltage matches the voltage required by the exhaust system.
Connecting:
1. When using an original Trotec exhaust system, also connect this, using the exhaust connection cable
included, to the exhaust cable connection on the laser.
2. Plug the ends of the exhaust hose into the exhaust nozzle that is intended for this purpose on the
exhaust system and on the laser. The position of the connector depends on the type of the exhaust
system.
3. Plug in the mains cable of your exhaust system into the mains socket.
Follow the operation and maintenance instructions in the Manual of the exhaust system.
57
To Next Page
Loading...
Need help?
General
