Trotec Speedy 360 flexx - Page 6

Content
2.8.2 Gases, fumes and dust........................................................................................................ 26
2.8.3 Reflection through materials.................................................................................................27
2.8.4 Information about damaged optics.......................................................................................28
2.8.5 Protective measures for damaged optics.............................................................................29
2.9 In case of emergency........................................................................................................... 30
3 Technical Data.......................................................................................................... 31
3.1 Dimensions and weight........................................................................................................ 31
3.2 Electrical requirements of the machine..............................................................................32
3.3 Exhaust system requirements............................................................................................. 33
3.4 Computer requirements........................................................................................................35
3.5 Materials................................................................................................................................. 36
4 Machine overview.....................................................................................................40
4.1 General overview...................................................................................................................40
4.2 Front door.............................................................................................................................. 41
4.3 Tables (multifunctional table concept)................................................................................41
4.3.1 Additional tabletops.............................................................................................................. 43
4.3.2 Table placement....................................................................................................................44
4.4 Lens(es).................................................................................................................................. 45
4.5 Nozzles................................................................................................................................... 46
5 Transport................................................................................................................... 47
5.1 Safety notes........................................................................................................................... 47
5.2 Delivery state......................................................................................................................... 47
5.3 Temperature and humidity................................................................................................... 49
5.4 Required tools for unloading and transport...................................................................... 49
5.5 Place of storage.................................................................................................................... 49
5.6 Transport inspection and reporting of defects..................................................................50
5.7 Unpacking the machine........................................................................................................51
5.8 Relocation of the machine................................................................................................... 52
6 Setup and installation..............................................................................................53
6.1 For your safety...................................................................................................................... 53
6.2 Temperature and humidity................................................................................................... 53
6.3 Space requirements.............................................................................................................. 54
6.4 Setup.......................................................................................................................................54
6.5 Connections........................................................................................................................... 55
6.5.1 Mains connection..................................................................................................................56
6.5.2 Connection the PC............................................................................................................... 56
6.6 Connection of additional components............................................................................... 57
6.6.1 Connecting an exhaust system from Trotec........................................................................ 57
6