Operation
7.7.2 Sonar Technology
TM
Caution
If the ultrasonic sensor is heavily soiled, the laser head may be damaged if it therefore hits the
material or the worktable.
1. Make sure that the ultrasonic sensor is clean.
2. Select the lens type in the menu bar of JobControl®.
3. Press the two keys from the Working table control button
Z simultaneously for the laser beam to get automatically
focused on the workpiece.
Focusing is then complete, and you can start the laser
processing.
Notice
This focusing mode is especially well-suited for all sound-relective materials.
72
To Next Page
Loading...
