C
C
a
a
l
l
i
i
b
b
r
r
a
a
t
t
i
i
o
o
n
n
Troxler calibrates the gauge at the factory and recommends that
it is always calibrated by an authorized Troxler service center. A
list of Troxler and authorized Troxler service centers are
provided at the front of this manual or at:
www.troxlerlabs.com/services.
The calibration range of the gauge’s density measurements is
from 1750 to 2700 kg/m
3
(approximately 110 to 170 pcf).
NOTE
Moisture content of the measured material can be
determined with an external device, such as the
Troxler Moisture Probe Model 6760 (included). Other
manual methods, such as an oven dry, may also be
used. If the Model 6760 is used, it is strongly
recommended that the results are compared to an
alternative moisture measurement and an offset
applied if needed (see p. 7-7) or a calibration profile
generated (see p. 5-15)
To Next Page
Loading...
