Troxler EGauge 4590 - Charging the Gauge

3–6
C
C
h
h
a
a
r
r
g
g
i
i
n
n
g
g
t
t
h
h
e
e
G
G
a
a
u
u
g
g
e
e
The gauge is equipped with a rechargeable nickel-metal hydride
(NiMH) battery pack containing five C batteries. Before turning
on the gauge, charge the battery for about 3 hours.
To charge the NiMH batteries:
1
1
.
. Plug the AC charger or DC adapter into the charger
connector under the gauge’s Port Cover (see Figure 3 on
page 3–3). The battery charge indictor icon ( ) appears on
the top-right of the display.
If using the AC charger, plug the other end of the charger
into a standard 100–240 V AC outlet.
If using the DC adapter, connect the other end to any 12-14
V DC source (such as a vehicle's power receptacle).
2
2
.
. After the gauge is fully charged (approximately 3 hours),
unplug the AC charger or DC adapter and store for later use.
For more information about batteries, see the Batteries section
on page A-9.