TSC Alpha-40L RFID

42
Item
Description
Default
Wi-Fi
Status
Check the Wi-Fi status
N/A
Configure
Set the Wi-Fi configure
DHCP
SSID
Set the SSID
N/A
Security
Set the security
Open
Password
Set the security key
N/A
Bluetooth
Status
Check the Bluetooth status
N/A
Local Name
Set the local name for Bluetooth
N/A
RFID
Control
RFID Active:
Select ON/OFF to enable/disable the RFID encoder module.
Error Handling:
This menu item selects the error handling mode for RFID failures.
Overstrike
(Default)
Each failed label prints with the Overstrike pattern and the form retries on a new label until the
Label Retry count is exhausted. Whether or not an error message will display or the failed
label will reprint depends upon the Max Retry Error setting.
None
No specific action is taken when a tag fails to be programmed.
Stop
The printer will halt and display the error message “RFID Error: Check Media.” The label is
discarded and reprinting of the label (if desired) must be initiated from the host. When the error
is cleared, the label with the failed tag moves forward until the next label is in position to be
printed.
Label Retry:
This menu item selects the number of label retries that the RFID encoder will attempt before declaring a fault. This
may indicate a problem with the RFID encoder, the coupler assembly, the printer setup, or the label stock.
Minimum
1
Maximum
10 (Default)
Max Retry Error:
This menu item determines if errors are declared when the Label Retry count is exceeded.
EPC Write Ctrl:
This option controls how the printer encodes the RFID tag EPC field.
Non-RFID Warning:
This menu item enables a warning to appear if the printer receives a print job that does not contain any RFID
commands when RFID media is installed in the printer.