TSC DA200 Series User Manual

- 11 -
3. Setup
3.1 Setting up the Printer
1. Place the printer on a flat, secure
surface.
2. Make sure the power switch is off.
3. Connect the printer to the computer
with the provided USB cable.
4. Plug the power cord into the AC
power cord socket at the rear of the
printer, and then plug the power cord
into a properly grounded power
outlet.
Note:
* Please switch OFF (O) printer power switch prior to plug in the power cord to printer power
jack.
* The interface picture here is for reference only. Please refer to the product specification for
the interfaces availability.

TSC DA200 Series Specifications

General

Resolution	203 dpi
Max Print Width	108 mm (4.25")
Max Print Length	2, 794 mm (110")
Processor	32-bit RISC CPU
Media Roll Diameter	127 mm (5") OD
Ribbon Core Diameter	25.4 mm (1")
Print Method	Thermal Transfer/Direct Thermal
Max Print Speed	6 ips (inches per second)
Memory	8 MB Flash, 8 MB SDRAM
Interface	USB 2.0
Media Sensor	Reflective, Transmissive
Media Handling	die-cut, fan-fold, continuous
Media Type	Gap, Black mark, Notch, Continuous
Media Width	20 mm ~ 112 mm (0.79" ~ 4.41")
Media Thickness	0.06 mm ~ 0.19 mm
Ribbon Width	30 to 104 mm
Ribbon Length	300 m (984 feet)
Power Supply	External universal switching power supply