TSC TA210 - Replacing the Black-mark Sensor Module

TA210/ TA310/ TA200/ TA300
Bar Code Printer Service Manual
14
3.4 Replacing the Black-mark Sensor Module
1. Please refer to the section 3.2
to remove the main board.
2. Remove the four screws to
take out the black mylar.
3. Remove one screw on the
black-mark sensor fixing plate.
4. Open the print head
mechanism to remove/replace
the black-mark sensor
module.
5. Reassemble the parts in the
reverse procedure.
Screws
Screws
Black-mark sensor
module connector