TSC TA210 - Page 23

TA210/ TA310/ TA200/ TA300
Bar Code Printer Service Manual
19
5. Pull the print head module forward to take out the module.
6. Disconnect the print
head harness.
7. Remove/Replace the
print head assembly.
Note:
There is static brush
adhered on the print
head module. Please
insert the print head
module carefully.
8. Connect the print head harness and carefully insert the print head module spring
plate into the ribbon base print head spring plate slot. Make sure the print head
bracket hinge slots are engaged with the hinges at both sides.
9. Reassemble the parts in the reverse procedures.
Print head
assembly