TSC TC200 Series

TC200/ TC300/ TC210/ TC310
Bar Code Printer Service Manual
30
3.11 Cutter Module Installation (Option)
1. Refer to section 3.2 to remove
the lower cover. Open the top
cover and pull up the front
panel from the printer.
2. Thread the cutter module
8-pin harness through the
front slot of lower inner cover.
3. Connect the cutter module
harness connector to the 8-pin
white socket on the printer
main board.
Note:
The connector located on J500
for TC210/TC310 series.
The connector located on JP35
for TC200/TC300 series.