Why is my TSC Barcode Reader missing printing on the sides of the label?
If your TSC Barcode Reader is missing printing on the left or right side of the label, the label size setup might be incorrect. Set the correct label size in your printer settings.
How to correct the printing position of small labels on my TSC TC200?
If the printing position of small labels is incorrect on your TSC Barcode Reader, recalibrate the media sensor sensitivity. Ensure the label size and gap size are correctly set. Fine-tune the Shift Y parameter using DiagTool. If using BarTender software, adjust the vertical offset in the driver settings.
What to do if my TSC TC200 is unable to use the SD card?
If your TSC Barcode Reader is unable to use the SD card, ensure that the SD card is not damaged and use a supported capacity SD card. Also, try reinserting the SD card to ensure it is correctly placed.
Why is the RTC time incorrect when I reboot my TSC TC200 Barcode Reader?
Check if there is a battery on the main board.
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 dpi |
| Processor | 32-bit RISC CPU |
| Memory | 8 MB SDRAM |
| Communication Interfaces | USB |
| Media Handling | continuous |
| Max Print Length | 110 inches |
| Sensors | Gap/Black Mark |
| Media Type | Roll feed, die-cut, continuous, fan-fold, tags, ticket in thermal transfer or direct thermal paper |
| Media Core Diameter | 1.0 inch, 1.5 inch |
| Power Source | AC 100-240V, 50/60Hz |
| Input | AC 100-240V, 50-60Hz |
| Output | DC 24V, 2.5A |
| Max Print Width | 4.25 inches |
| Max Print Speed | 6 ips |
| Label Length | 0.39 inches to 110 inches |
Details the front view of the TC210 and TC200 series printers, including component identification and SD card specifications.
Illustrates and labels the internal components and parts of the printer.
Depicts the rear panel of the TC210 and TC200 series printers, highlighting interface ports.
Identifies and lists various connectors on the main board of the TC200/TC300 series printers.
Details the pin assignments and functions for RS-232C, USB, Centronics, and Ethernet interfaces.
Step-by-step guide to replace the LED or LCD module in the printer.
Instructions for removing and replacing the main logic board of the printer.
Procedure to replace the head open sensor component.
Guide on how to remove and install a new platen roller assembly.
Steps for safely removing and replacing the print head assembly.
Instructions for replacing the stepping motor, including different DPI models.
Procedure to replace the black-mark sensor module.
Guide on replacing the gap sensor (transmitter).
Steps for removing and installing the media holder assembly.
Instructions for installing the optional peel-off module.
Guide for installing the optional cutter module.
To Next Page
