Why is my TSC Printer showing an error?
An error on your TSC printer may be due to a lack of labels or ribbon, or incorrect printer settings. To resolve, load a fresh roll of labels or ribbon, following the loading instructions, and then press the FEED button. If the issue persists, initialize the printer using the instructions provided in “Power on Utility” or “Diagnostic Tool” to correct the printer settings.
How to fix poor print quality on my TSC Printer?
To improve print quality on your TSC printer: ensure the top cover is completely closed and latched properly on both sides. Verify that the connected power supply provides a 24V DC output. Reload the supply to ensure it is correctly loaded. Also, inspect the print head for any accumulated dust or adhesives and clean it if necessary.
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 DPI (8 dots/mm) |
| Model | TTP-225 Series |
| Memory | 8 MB Flash, 4 MB SDRAM |
| Interface | USB 2.0 |
| Processor | 32-bit RISC |
| Type | Barcode Printer |
| Supported Barcodes | Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, Interleaved 2 of 5, Codabar, POSTNET |
| Operating Temperature | 5 ~ 40°C (41 ~ 104°F) |
| Humidity | 85% RH (non-condensing) |
| Media Type | Continuous, Die-Cut Labels |
| Storage Temperature | -40 ~ 60°C (-40 ~ 140°F) |
Overview of the TSC bar code printer's features and performance capabilities.
Lists the safety and regulatory compliances for the printer, including CE, FCC, UL, CUL, C-Tick, and TÜV.
Crucial safety information regarding hazardous parts, battery risks, and proper disposal.
Guide on how to unpack the printer and verify all included items are present.
Visual identification of the printer's main external components.
Identifies components on the front of the printer, such as LCD display and buttons.
Identifies internal components of the printer, like print head, sensors, and rollers.
Identifies rear ports and interfaces, including power, USB, and serial connections.
Step-by-step instructions for initially setting up the printer on a surface.
General instructions for loading different types of media into the printer.
Detailed procedure for loading standard media rolls into the printer.
Instructions for loading media specifically for the peel-off label dispensing function.
Instructions for loading media when using the printer's cutter function.
Procedure for loading thicker media, requiring adjustments to the printer's internal guides.
Step-by-step guide on how to properly install the thermal transfer ribbon.
Introduction to the diagnostic utility for printer configuration and troubleshooting.
Details on printer functions like sensor calibration, Ethernet, and RTC setup via the diagnostic tool.
Guide on configuring Ethernet settings using the diagnostic utility.
Steps to configure the printer's Ethernet using a USB connection.
Steps to configure the printer's Ethernet using an Ethernet connection.
Instructions for installing a MicroSD card into the printer.
Guide on using a USB keyboard with the printer for stand-alone operations.
Explanation of the LED colors and their meanings indicating printer status.
Description of the primary functions of the printer's feed button.
Overview of special functions activated by powering on the printer with the button held.
Procedure for calibrating the gap or black mark sensor for media detection.
Steps for calibrating sensors, performing a self-test, and entering dump mode.
Process to reset printer settings and clear memory to factory defaults.
Instructions to set the black mark sensor for media detection and calibrate it.
Instructions to set the gap sensor for media detection and calibrate it.
Method to bypass the automatic execution of the AUTO.BAS program on startup.
Common printer issues identified by LED status and their recovery procedures.
Lists various printing issues and their possible causes and solutions.
Explains LCD messages and provides solutions for encountered printer errors.
To Next Page
