TTP-245C/ TTP-343C/ TTP-244CE
Bar Code Printer Service Manual
20
3.8 Peel-off Module Installation (Option)
1. Refer to section 3.2 to remove the lower cover.
2. Open the top cover and pull up the front panel from the printer. Thread the 5-pin peel-off
module harness through the front slot of lower inner cover.
3. Plug in the peel-off module harness connector to the 5-pin red socket on the main board.
4. Embed the tenons into the both sides mortise of lower inner cover and close the peel-off
cover.
To Next Page
