TSC TTP-384M - Diagnostics; Print Config

3.3 Diagnostics
Diagnostics
ExitPrint Config. Dump Mode Rotate Cutter
3.3.1 Print Config.
This feature is used to print current printer configuration to the label. On the
sconfiguration printout, there is a printhead test pattern, which is useful for checking if
there is any dot damage on the printhead heater element.
Diagnostics 1/4 Self Test ... Printing ...
> Print Config. 1/1
Dump Mode
Rotate Cutter
Self-test printout
Printhead check pattern
Model name and F/W version
Printed mileage (meter)
Firmware checksum
Serial port configuration
Code page
Country code
Print speed (inch/sec)
Print darkness
Label size (inch)
Gap distance (inch)
Gap/black-mark sensor sensitivity
Numbers of download files
Total & available memory space
40