Moving and Shipping 3-5
6. Place the classifier in the original packing provided by TSI Inc.
a. Place the classifier in the smaller of the two boxes, securing it
within the lower foam inserts.
b. Place the upper foam insert over the classifier. Close and tape
the box.
c. Rest the box containing the classifier on the foam corner inserts
in the large box. Position the upper foam inserts and tape the
box shut.
d. The classifier is now ready for shipping.
Note: If you require an impactor calibration, return the impactor(s)
when you return the Electrostatic Classifier to TSI.
To Next Page
Loading...
