TSN Box Development – TSN Box 3.0 Getting Started Guide
About:
2.5.4.15 Configuration/Sync Control
***CURRENTLY NOT AVAILABLE***
This page allows configuring the sync control service. Presently two options are available for sync, PTP and UES-
BNC. PTP sync is not yet supported but UES-BNC sync is available.
2.5.4.16
External Switch Configuration (Q5050 support only)
The unit is able to configure UMAN standalone Q5050 switches remotely. Currently, the unitcan configure the PTP
port settings of a given Q5050 switch. To use this interface, enter the MAC address of the switch in the input field.
Once done, the interface will auto-populate with the settings available on the selected switch.
The "Settings" button on each port in the table shows all the available PTP options.
2.5.4.17 Settings/Update Firmware
Firmware can be applied via this page. A reboot is necessary after new firmware has been applied:
To Next Page
Loading...