TSN Systems Box 3.0 - USB 3.0; USB Serial Debug Port; Host Ethernet

TSN Box Development – TSN Box 3.0 Getting Started Guide
Hardware – 9
2.4.4 USB 3.0
One USB3.0 Type A connector isavailable on the host side of the unitand is connected to the host PC. Pin
descriptions are shown below:
2.4.5 USB Serial Debug Port
The USB Serial Debug Port is connected to a FTDI USB to Serial converter chip. This serial channel is then
connected to the second serial port of the Host PC and is used for debugging purposes. A USB Type B cable is
required. FTDI VCP drivers may be required depending on OS.
2.4.6 Host Ethernet
The host Ethernet port is on the Host side. A standard RJ45 Ethernet cable is required; default IP address of the host
is 192.168.41.250.
