Need help?Do you have a question about the TSN Systems Box 3.0 and is the answer not in the manual?
General| Brand | TSN Systems |
|---|---|
| Model | Box 3.0 |
| Category | Inverter |
| Language | English |
Overview of the unit's high-performance analysis tool features.
Details the unit's base board and module slot configurations.
Specifies the chassis dimensions and mass of the unit.
Lists and describes the various hardware components and connectors.
Details the connectors and their numbering on the TAP side of the unit.
Describes the connectors on the host side of the unit.
Explains the USB 2.0 Type A connectors on the host side.
Details the USB 3.0 Type A connector on the host side.
Describes the USB Serial Debug Port for debugging purposes.
Provides information about the host Ethernet port, including its default IP address.
Details the isolated inputs and outputs, and their pin descriptions.
Explains the audio ports, output/input channels, and pin descriptions for CPU/FPGA modes.
Describes the Dual 1Gb Ethernet modules, 1000BASE-T and 1000BASE-T1.
Details the Quad 100 Mbps modules, 100BASE-T1 and 100BASE-TX.
Explains the CAN module, its DE-9 connector pinout, and termination switches.
Describes the SYNC module's BNC connectors and modes (Sync Mode, PPS Mode).
Details the PPS IO connectors, function, and electrical specifications.
Describes the reset button functionality for cold restarts.
Explains the recovery button for emergency software recovery or factory restore.
Details the unit's power inputs, voltage range, and current load.
Explains the importance of chassis connections for T1 ports.
Provides guidance on ventilation and operating temperatures for the unit.
Lists the requirements for using the web interface.
Guides on powering up the unit and initial setup for the web interface.
Explains how to discover the unit's IP address on the network.
Overview of the web interface for configuring and performing basic functions.
Configuration for emitting best effort packets on port 1.
Setup for emitting burst packet traffic with PTP as master.
Configuration for burst packet traffic with automotive PTP in master mode.
Configuration for burst packet traffic with automotive PTP in slave mode.
Configuration for burst packet traffic with PTP in slave mode.
Configures the unit for full tapping mode on FPGA ports 1-6.
Describes playing back pcapng files with PTP in master mode.
Configuration for playing pcapng files with automotive PTP as master.
Configuration for playing pcapng files with automotive PTP as slave.
Configuration for playing pcapng files with PTP in slave mode.
Configures the unit for MAC interface on T1 port 1 as Slave.
Newer version for applying and editing configurations.
Web version of SsfEdit for module connection management.
Displays statistics like CPU usage, memory, and network usage.
Allows configuration of network, power, ports, sync, logs, and about info.
Configures the sync control service for PTP and UES-BNC.
Allows remote configuration of Q5050 switches and PTP port settings.
Provides the interface for applying firmware updates.
Allows changing the main account's password.
Describes managing user accounts on the unit.
Lists known issues and workarounds for the web interface.
To Next Page