TSN Box Development – TSN Box 3.0 Getting Started Guide
Known current issues for the web interface:
• If the unit is power cycled with the Packet Generator configuration enabled, updating the current firmware
will not work. To get around this, activate any other configuration that is not the Packet Generator and
firmware updates should
work normally. This issue is relevant to versions 623 - 624 of the firmware.
• If ports 1-8 are connected but the link status reported as down, re-applying the config will bring up the ports
related to the selected configuration.
• After the unit powers up, reapply the selected configuration to ensure that the unit is set up correctly.
• Modules Configuration issues:
• Packet generator with burst does not work properly. Use Modules Configuration v2 instead.
• Modules Configuration (v2) issues:
• Shipped configuration files cannot be deleted.
• Configuration files cannot be edited yet.
• Configuration files are not filtered by currently active preset - they are all clumped together.
• For uploaded files, the name of configuration file must be the same as the name defined in the
configuration file itself or else the file won't upload.
To Previous Page
Loading...