FUNCTION
UPWARD
DOWNWARD
F button is used to enter functions, Calibration and Set Up Menus.
It is used for strolling Upward Direction between
progamming and calibration menus.
It is used for strolling Downward Direction between
progamming band calibration menus.
SET TO ZERO Zero button is used to make displayed weight value
zero. In order to set weight to zero conditions given
Below must be satisfied:
§ Weight display is in standstill condition
§ Tare is reset
§ Gross weight is in previously selected manual zero
range
§ Indicator is not in set up mode, or in failure mode
It is also used to move cursor left during
alphanumerical or numerical data entries.
PRINT Print button is used to print Weig
hing result
Or save it
Into alibi memory. (
This button is disabled if
continuous data transmit mode is active, please see
the section for serial communication. Pressing to this
button causes to print provided that:
§ Indicator' s manual transmit has correspondingly be
activated
§ The weight display is in standstill condition
§ Weight vaule is greater than min printable amount
selected before not in set up mode, or in failure
mode.
11
F
To Next Page
Loading...