TurboChef i5 Owner's Manual

TROUBLESHOOTING
Troubleshooting
The following is a list of fault codes and error messages, along with the possible problem(s) that the oven may
experience. Please attempt the recommended action before calling Customer Support (800.90TURBO, +1
214.379.6000) or your Authorized Distributor.
If any fault or error message occurs that is not listed below, contact Customer Support (800.90TURBO, +1
214.379.6000).
NOTE: Any fault codes listed in bold will terminate a cook cycle upon discovery. F6 will not terminate a cook
cycle; however, it will alert the user of a possible air circulation problem.
WARNING: Food, oven door, and oven cavity are hot! Use extreme caution when troubleshooting
the issues below.
Issue Possible Cause(s) Resolution
No power to
oven.
- Oven is not plugged in.
- Main circuit breaker is tripped.
- Plug the oven in.
- Verify the wall circuit breaker is on. Reset the
breaker, then power the oven back on.
Oven is not
warming up
properly.
- Oven is in the Off state.
- Door is not closed.
- Oven has been switched off at
the main circuit breaker.
- High-limit thermostat tripped
- Touch “Menu” and then a set temperature.
- Close the cook cavity door.
- Turn the oven off and unplug the oven – leave
for two minutes. Re-plug in the oven, switch on
the isolator/main power supply, and touch
“Menu” and then a set temperature.
- Press the button located on the oven rear wall
(near the power cord) to reset the high-limit
thermostat.
Display reads
“Oven Door
Open” and alarm
sounds.
- Food obstruction preventing
door from closing.
- Oven door is open.
- Door switches are out of
alignment.
- Open the door and remove the obstruction.
- Open and close the door several times.
- Call Customer Support.
Oven is not cook-
ing properly.
- Incorrect oven model specified.
- Oven is not clean. (Large
deposits of grease, carbon, or
food debris dilute the
microwave.)
- Incorrect group and/or item name
was selected for the product.
- Product was not cooked from
correct starting state (for
example, chilled or frozen).
- Product out of specification.
- From the Info Mode Manufacturing screen,
ensure that the oven model is set correctly (“i3”
or “i5” depending on the oven).
- Clean the oven following the cleaning
instructions on pages 8-9.
- Ensure the correct food group and/or item
was selected.
- Ensure the product was in the correct state
before being placed in the oven.
- Ensure the product is exactly the same weight/size
as the typical product.
Oven is not
beeping.
- Bad boot up when power was
cycled.
- Unplug the oven for 30 seconds and plug the oven
back in and see if the issue is resolved. If not, call
Customer Support.
31

TurboChef i5 Specifications

General

Brand	TurboChef
Model	i5
Category	Oven
Language	English