turck TBEN-S2 - Page 152

Parameterizing and Configuring
Configuring the devices at EtherNet/IP
152
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
Class 152 (0x98) – Basic
This class data and parameters for the device’s basic functions.
Applies to:
n TBEN-S1-4DIP-4DOP
Attribute no. Designation Get/
Set
Type Meaning
Dec. Hex.
Parameters
1 0x01 Manual reset after
overcurr. ch4
G/S USINT 0: no
1: yes
2 0x02 Manual reset after
overcurr. ch5
G/S USINT 0: no
1: yes
3 0x03 Manual reset after
overcurr. ch6
G/S USINT 0: no
1: yes
4 0x04 Manual reset after
overcurr. ch7
G/S USINT 0: no
1: yes
5 0x05 Overcurrent VAUX1 ch0…3 G USINT 0: -
1: active
6 0x06 Overcurrent VAUX1 ch4…7 G USINT 0: -
1: active
7 0x07 Diagnostics ch4 – overcurrent G USINT 0: -
1: active
8 0x08 Diagnostics ch5 – overcurrent G USINT 0: -
1: active
9 0x09 Diagnostics ch6 – overcurrent G USINT 0: -
1: active
10 0x0A Diagnostics ch7 – overcurrent G USINT 0: -
1: active
11 0x0B Input value ch0 G USINT 0: off
1: on
12 0x0C Input value ch1 G USINT 0: off
1: on
13 0x0D Input value ch2 G USINT 0: off
1: on
14 0x0E Input value ch3 G USINT 0: off
1: on
15 0x0F Output G BYTE Bit 0: Output value ch4
bit 1: Output value ch5
bit 2: Output value ch6
bit 3: Output value ch7