turck TBEN-S2 - Grounding the device - mounting on a mounting plate

V04.00 | 2021/05
25
5.6.5 Grounding the device – mounting on a mounting plate
 For mounting onto a mounting plate: Fix the TBEN-S module with an M4 metal screw
through the lower mounting hole.
a The shielding of the M8 flanges for the I/O level is connected to the reference potential of
the installation via the M4 metal screw.
a With mounted grounding clip: The shielding of the fieldbus is connected to the reference
potential of the installation via the module grounding of the I/O level.