2.1 Safety Notes
l All new autoclave users must undergo a period of training in proper usage
under an experienced employee.
l Before initial use, check the autoclave chamber to ensure that no
packaging materials have been left inside.
l Before use, check inside the autoclave chamber to ensure that no items
have been left from the previous cycle.
l Always verify that you have chosen the appropriate sterilization program
l After the cycle, open the door slowly to allow steam to escape and wait 20
seconds before you remove the load.
l A certified inspector must perform a periodic pressure chamber safety test
according to the local regulations.
l Once a year, or more frequently, effectiveness tests must be performed,
i.e., calibration and validation.
l Make sure there are no leaks, breaks, blockages, whistles or strange
noises.
l Perform maintenance operations as instructed. The owner of the autoclave
is responsible to perform the maintenance operations.
l Notify the person in charge immediately of any deviation from the normal
functioning of the device.
l Protective equipment and clothes and other safety instructions shall be
implemented in accordance with local and national regulations and/or
rules.
Page 16
To Next Page
Loading...
