37
MAINTENANCE
MAINTENANCE
SELF - MAINTENANCE PROCEDURES
BATTERY
Battery is located at the front end of utility box below
the seat and covered by the cover front. The cover
front must be removed to access the battery. Follow
the procedure for removal:
1. Take out the floor mat. Remove the bottom
mounting screws (A) of cover front.
2. Open the seat and remove the top mounting
screws (B) from both the sides of cover front.
A
A
B
3. Gently pull out the cover front by dislocating its
lugs.
4. Inspect the battery electrolyte level. It should be
between minimum and maximum level.
5. If the electrolyte level is below minimum level,
add only distilled water upto the maximum level
by removing the filler caps.
6. Reinstall the filler caps and clean the battery
thoroughly, apply petroleum jelly to the battery
terminals to protect from corrosion.
Incase of any abnormality or for removal of battery
from the vehicle, contact TVS Motor Company
Authorised Distributor or Dealer / Authorised Service
Centers.
Once the battery is charged initially, never add diluted
sulphuric acid. Use only distilled water for topping up. Never
add tap water. Never check the battery charge by shorting
terminals. Always connect the positive terminals first and the
negative to avoid sparking. Do not obstruct, bend or change
the routing of the battery vent tube. Make sure that the vent
tube is firmly attached to the battery and the other end is open
and clear.
Caution
To Next Page
Loading...
Need help?
General
