39
MAINTENANCE
MAINTENANCE
4. Close the fuse case and re-fix it in the battery
band.
5. Turn ‘ON’ the ignition switch and check for proper
functioning of electrical systems. Incase the fuse
fails again, consult the nearest TVS Motor
Company Authorised Distributor or Dealer /
Authorised Service Centers.
Do not use vehicle by shorting the wires without a fuse. This
may result in overheating of electrical / wiring and may result
in fire. Do not use fuse of higher amperage than specified for
the safety of electrical system.
Caution
SPARK PLUG
1. Open the cover front as explained earlier.
2. Clean the dust and mud around the spark plug
mounting to avoid falling inside the cylinder.
3. Pull out the suppressor cap from spark plug.
Using the spark plug spanner, remove the spark
plug.
A spark plug with heavy carbon deposits will not
0.9 ~ 1.0 mm
A
B
produce strong sparks. Hence, only if necessary, clean
the carbon deposits from the spark plug with a small
wire brush or spark plug cleaning tool.
Inspect the spark plug electrodes (A) and (B) for
corrosion. If found replace the sparkplug with new.
Inspect the spark plug gap with a wire gauge / feeler
gauge. Readjust the sparkplug gap to 0.6 ~0.7 mm
(for Wego) and 0 ~ 1.0 mm(for Wego Refresh) if .9
required.
After cleaning and adjusting the gap, reinstall the
spark plug and tighten by hand to avoid cross
threading. Finally tighten using spark plug spanner.
To Next Page
Loading...
Need help?
General
