Tyco Kendall Kangaroo Joey - Keep Tube Open (KTO) Feature; Lock Screen Feature

KANGAROO JOEY
™
18
Enteral Feeding Pump
Figure 15A. RUNNING mode screen
for continuous feed mode.
Figure 16. Program Locked screen,
which indicates the pump is in LOCK
SETTINGS mode.
KTO (Not Available in EZ Pump Mode)
The Keep Tube Open (KTO) function within the KANGAROO JOEY Enteral Feeding Pump will help prevent a blockage of the feeding set
by moving the feeding solution periodically within the tube. On regular intervals, calculated from the pump’s presently programmed
feed rate, a small and clinically insignificant portion of feeding solution is moved through the tube. The amount of delivered fluid
is monitored, tracked, and calculated into the final feed volume totalizer amounts displayed to the user. The KTO feature can be
activated via the RUNNING screen. To activate the KTO feature, press the input button to the left of the KTO icon, see Figure 15A,
to immediately input a desired time in minutes for which the pump will remain in the “Keep Tube Open” mode before resuming the
previously programmed feeding regimen. Each press of the input button will increment the KTO time by 5-minute increments, up to
30 minutes, see Figure 15B. After “30” is reached, each additional button press will increment in larger time steps, up to a maximum
of 240 minutes. Another button push after 240 will cycle the KTO back to 5 minutes. No other input is needed to start the countdown,
as the time immediately counts down after the incremental value is reached.
Lock Screen Feature
The KANGAROO JOEY Enteral Feeding Pump can be set to RUN and then be locked out from unintended use. While the LOCK
SETTINGS feature prevents changes only to the input parameters, the LOCK SCREEN feature will lock out any button presses,
including RUN or HOLD, except power off.
Use LOCK SCREEN when the pump is running and there is a need to prevent unintended button activation, such as putting the pump
into an unwanted HOLD. The RUNNING screen will show a padlock to indicate that no changes can be made without unlocking the
screen.
To lock the screen, use the following procedure while the pump is in RUNNING mode:
• Press and hold the third4button from the top (with padlock next to it) for at least 4 seconds, and then release it.
To unlock the screen, use the same procedure above.
Figure 17. Padlock
indicates pump is in
LOCK SCREEN mode.
Figure 15B. KTO.