KANGAROO JOEY
™
3
Enteral Feeding Pump
Figure 1B. KANGAROO JOEY Enteral Feeding Pump set loading area.
Section II — Safety and Warnings
CAUTION: U.S. federal law restricts the sale of this device to physicians or to their direct representatives.
1. Read this booklet thoroughly before using the KANGAROO JOEY Enteral Feeding Pump.
2. Do not use this device near flammable anesthetics.
3. Disconnect power supply before cleaning or servicing.
4. The KANGAROO JOEY Enteral Feeding pump utilizes a two prong, medical grade power supply cord specifically designed for use only with
the KANGAROO JOEY feeding pump’s Lithium Ion battery charging circuit. Use of an alternate consumer style power cord or DC car
adapter may cause damage to the charging circuit and battery of the KANGAROO JOEY feeding pump. Use only the supplied
power adapter to charge your KANGAROO JOEY feeding pump from an AC power source. Use only KANGAROO JOEY Enteral Feeding Pump
power cord (with built-in A/C adapter) with pump. See Section XIII - Service Part Numbers for replacement of power cord.
5. Use only KANGAROO ePump Enteral Feeding Pump sets with this device. Pump is not compatible with other pump sets.
6. For re-certification, see Section VI - Re-certification of Performance. For other integrity checks, consult with a qualified Biomedical
Technician or contact the manufacturer (Section XI - Customer Service).
7. For service or for technical information, please contact Customer Service (Section XI).
8. Do not open the main housing, as there are no user-serviceable parts inside. Opening may affect function of device and voids the warranty.
To replace battery, see Section VIII.
9. Dispose of old battery-powered electronic equipment in a manner consistent with institutional policy for expired equipment disposal.
10. Cleaning frequency and practices must be consistent with institutional policy for cleaning of non-sterile devices. See Section VII - Cleaning,
for instructions on cleaning the KANGAROO JOEY Enteral Feeding Pump.
11. See icon descriptions in Section III - Icon Identification and Section X - Specifications and Symbols for additional safety information.
12. This device is designed to minimize the effects of uncontrolled electromagnetic interference and other types of interference from external
sources. Avoid use of other equipment that may cause erratic operation or degradation in the performance of this device.
13. WARNING: The serial I/O port (see Figure 1A) is intended only for use by the manufacturer.
Any accessory equipment that can be connected to the serial I/O port, and which does not comply with the equivalent safety requirements
To Next Page
Loading...