3
Tractor Model ET 350 ECONO
Oil pump type CBN316L
Opening pressure of relief Valve(MPa) 13.7
Hydraulic cylinder
Type Horizontal, single-action piston type
Bore(mm) 85
Stroke(mm) 110
Distributor Sliding valve control type
Rated lift capacity(at hitch shaft)(kN) 8.33
Suspension linkage
Type Rear-mounted, three - point ball joint, category I
Upper hitch pin diameter(mm)
Lower hitch pin diameter
Power take-off shaft
Type Non-independent or semi-independent
Dimensions of spline
PTO Speed(r/min) 540,1000
Electrical system
Type 12V, Negative-grounded, single-line system
Alternator JF11(14V,350W) or FWB 15C31
Regulator FT-70 or FT-111
Starting motor QD146
Battery 6-QA-90
Head light 12V upper beam 45W. Lower beam 40W
Tail light 12V 32CP
Multi - indicating panel
Filling capacities(ℓ)
Fuel tank 40
Engine cooling system 7~9
Engine oil sump 4.5
Fuel injection pump 0.3
Hydraulic oil tank 5.7
Chassis 20.8
Hydraulic lift 7
Front drive axle 6
Intermediate Housing 3.5
φ 19
φ 22.4
+0.33
+0
+0.51
+0.30
8-spline-38 X 29 X 6 or
6-spline-34.79±0.06 X 28.91 ± 0.05 X 8.69
+0.032
+0.100
0
-0.28
-0.04
-0.01
-0.040
-0.098