typical GT856D - Sewing of the left;right T Stitch pattern; Sewing of ROM pattern

13
2.6 Sewing of the left/right T Stitch pattern
For example:Sewing the Left T Stitch with 5 straight stitch and 2 repeated T
stitch( 7 =02 )
■Operation Steps
1) Press the Standard Pattern 7 key. The indicator nearby the key will turn
on.At same time the main display area show 7-05 for a second and show
the work width of the pattern after that.
2) If you want to change pattern’s shape, press “Set” key. The width data in
main display area will blink. At this time you press the Standard Pattern 7
key, the main display will show pattern shape code “7-05”.
3) Press Increase or Decrease key to change straight stitch number. 05
means there is 5 straight stitch between left T stitch. The straight stitch
number can be set from 1 to 99.
4)
Press N2+ key. The main display shows “7=02”. At here you can set the
repeated time of the T stitch. “02” means the T stitch will be repeated 2
times. The repeated time can be set from 1 to 99. If you set digit to
“7=00”, the shape becomes Bline stitch pattern.
5)
If you press N2- key, the main display show “7-05” again, you can
change straight stitch number again.
6) Press “Set” key to confirm your choice. Then the main display shows the
work width of the pattern again.
7) Press the pedal and beginning your sewing.
■Note
The sewing of the Right T stitch is similar as aboved.
2.7 Sewing of ROM pattern
After you press “ROM pattern” key, you can sew the current ROM pattern.
The machine can store up to 1000 ROM patterns, coding from P000 to P999.You
can select one of ROM patterns as current ROM pattern. The operation step to set the
current pattern is:
1) Press “Set” key, the width data shown in the main display blinks.
2) Press “ROM Pattern” key, the main display shows the current ROM pattern
code which is blinking.
3) Press “+”/ “-” key to change the pattern code.
4) Press “Set” key to confirm the change. The display shows the work width data
and stop blinks.