typical GT856D - Setting the Position of the Sewing Base line; Needle Left;Right Stopping

17
2.12 End Condensation Operation
■ Operation Steps
1) Press “End condensation” key in the normal state, the indicator nearby
the key will be lit up. The main display will show the number of
condensation stitches in the “C” side. Such as “C-**”
2) Press “End condensation” key for sencond time, the main display will
show the number of condensation stitches in the “D” side. Such as
“d-**”.
3) Press “End condensation” key for third time, the main display will show
the width of condensation stitches. Such as “U-**”.The data range is
0.0~8.0mm.If you press “End condensation” key for fourth time, then the
end condensation operation will be cancelled and the indicator for end
condensation is off and the indicator for pattern width is lit up. Then the
main display will show the pattern width.
4) Press “Width” key, the main display will show the pattern width.
5) Press forward the pedal to start sewing.
6) After finish the sewing, press the pedal backward to do end condensation.
If the indicator for end condensation is on, the specified numbers of
stitches for condensation is sewed first, then follwed is the action of
trimming thread .
■ Setting steps for condensation stitches and width
1) Press “End condensation” key in the normal state, the indicator nearby
the key will be lit up. The main display will show the number of
condensation stitches in the “C” side. You can press the conrresponding
“+”/ “-” key to change this value. The data range is 0~99 stitches.
2) Press “End condensation” key for sencond time, the main display will
show the number of condensation stitches in the “D” side. You can press
the conrresponding “+”/ “-” key to change this value. The data range is
0~99 stitches.
3) Press “End condensation” key for third time, the main display will show
the width of condensation stitches.Such as “U-**”.To change this value,
press “Set” key, then the value start to blinks, you can press
conrresponding “+”/ “-” key to change this value. The data range is
0.0~8.0mm.
4) Press “Set” key to save all the changes made.
5) Press pedal to start sewing.
6) After finish the sewing, press the pedal backward to do end condensation
and thread trimming.
■ Note
1) The speed of end condensation: when the work speed is larger than 1200