29
P-20 Feed forward direction
compensation pulse count
0~9 0
P-21 Feed reverse direction
compensation pulse count
0~9 0
P-22 Working time on the Test
Run mode
1~60 5 s
P-23 Pause time on the Test
Run mode
1~60 5 s
P-24 Max.sewing speed of the
patterns with variable feed
pitch
400~3500 3500 spm
P-25 Whether allow the arm
shaft motor working or
not
0-Prohibit,
1-Allow
1
P-26 Feed Origin Sensor’s
polarity
0-Normal
1-Reverse
0
P-27 Zigzag Origin Sensor’s
polarity
0-Normal
1-Reverse
0
P-28 Up needle position 0~1439 100
P-29 Read the present
encoder’s position
0~1439 Read-only
P-30 Inner high gear’s start
speed
100~2000 1500 Read-only
P-31 Min. time interval from
the pedal stop to re-start
0~500 200 ms
P-32 Offset of zigzag start
move position
-100~+100 0 Read-only
P-33 The time of the zigzag
axis search origin
70~300 100 Read-only
P-34 The time of the Feed axis
search origin
70~300 90 Read-only
P-35 Buzzer Beep time 0~100 60 ms Read-only
P-36 The Min.Sewing speed 100~500 100 spm
P-37 Open angle of the thread
nipper
0~360 90 °
P-38 Close angle of the thread
nipper
0~360 340 °
P-39 Open angle of the thread
wipper
0~360 30 °
P-40 Soft-Start enable control 0:disable
1:enable
1
P-41 Sew speed of 1st stitch 100~5000 400 spm
P-42 Sew speed of 2nd stitch 100~5000 800 spm
To Next Page
Loading...
