216
power on the robotic arm for 6 hours every 3 months to charge the built-
in battery of the robotic arm.
When powering on the robotic arm, please release the emergency stop
button on the control box, and the robotic arm does not need to be
enabled.
2.Clean
After the robotic arm is used for a long time, there may be dirt or grease
on the carbon fiber shell (in rare cases, a small amount of grease can be
seen at the joints, which will not affect the normal use or life of the
joints). You can use 95% alcohol or 70% isopropanol to wipe the carbon
fiber surface for cleaning.
Note:
When cleaning the carbon fiber surface, be careful not to let the liquid
penetrate the joints.
To Next Page
Loading...
